8 3/4 gear setup
This will be a picture of the two caps off of a 489 housing against each other. You will notice they form a perfect circle. Which tells us that the other side of this is the housing must also form a perfect half circle so whoever comes up with this that the Caps are not cut in the center is full of crap.
I also took measurements around the circle to make sure it was a circle. The only way these caps would work if they were not split at the center of the hole would be if one side was u-shaped.
This will be a picture of the two caps off of a 489 housing against each other. You will notice they form a perfect circle. Which tells us that the other side of this is the housing must also form a perfect half circle so whoever comes up with this that the Caps are not cut in the center is full of crap.
I also took measurements around the circle to make sure it was a circle. The only way these caps would work if they were not split at the center of the hole would be if one side was u-shaped.
