What's up with these new rotors?

Dicer said
Maybe using a small rotary file (pencil grinder) and make new notches.....that way the notches will be there for the next time.

toolmanmike said
The Chinese didn't copy the originals to the letter like they said they would. LOL

And exactly why I got them from Napa at a bit more cost, hoping to avoid things like this.:D

:wtf::BangHead::BangHead::BangHead:

Blind Squirrel said
I'd drop in the smallest washer that would hit the bottom of the race. Tack weld in about four spots mid race and drive out from the rear.

BigBlockMopar said
Weld a piece of steel rod in/across the race and knock it out.
Then file 2 notches in the rotor for the next time

mderoy340 said
Cut 2 grooves diagonally across the race 180* apart. Hit with a sharp chisel and the race will crack in 2 pieces. Wear goggles!

All the above are possibilities I have as options.
A big washer welded in to the race was one of my best thoughts I think.
Then use my die grinder to cut access recesses for next time.

I also considered using my Mototool to cut the races in half.