Hello Members. I did get my rear side glass installed which was a bit of a challenge.....read the directions first, and take good notes. I did not do that. Anyway, the two door hard top does not use that lift triangle piece as the sedan does shown in pic Window Lifts II, 001. That is where I ran into a bind, and I had to do some additional research....but there it was under 2dr HT rear glass right in the FSM. The 2dr HT uses a lift bar on the rear side glass as shown in the pic marked Rear Glass Lift Bar 001 and shown installed in pic #Gas Tank and Rear Side Glass 004. I also installed the gas tank. Just a note, install the gas tank first, then install the filler tube as it is near impossible to do it the other way around. As well, be sure the sending unit wiring is not tucked up under between the top of the gas tank and the trunk floor before tightening the J-Hook.....yeah, that is what I did x**$^^^-. I had to loosen the J-Hook from the gas tank strap to get it back out. Nobody else would do that, I am sure...just me. Seems I make a bunch of extra work for myself. Tomorrow, I am going to start assembling the doors. BTW, I bought a jack instruction decal from Classic Industries a while back. Would anyone know the OEM spot to place this decal? Thanks for the information and for following along. sgrip65
View attachment 1715326361
View attachment 1715326362
View attachment 1715326372
View attachment 1715326376
View attachment 1715326379
View attachment 1715326380
View attachment 1715326381
View attachment 1715326382
