Jb Weld on aluminum intake

Splashzone epoxy is one of the better epoxies out there for this job but is probably overkill. I have a Victor340 intake that I was porting for myself and went through on one of the runners. It is an easy repair from outside and if I was better welding aluminum I would weld it but I'm not so it will get either some Splashzone or JBWeld from the outside of the runner. Here is a post on some epoxy testing I did for myself years ago.


https://board.moparts.org/ubbthread...-epoxy-test-coated-and-un-coated-results.html