What would you do,???.
Working on my stock bore 1975 360, and this is what I found on cyl #3 high on the side. Bad pitting. Don't know what course to follow. I had not planned on a rebore, just clean the block up good, and a real good hone, with new Keith Black pistons, Scat Rods, new rings, bearings etc. All other cyls are fine, just #3.
The pitting is pretty deep, probably .050inch at deepest spot.. I'm stressed out on this, had this block a long time never knew it. Was going to install it in my 66 B-Cuda. Don't have big bucks to play with.
Dave
Working on my stock bore 1975 360, and this is what I found on cyl #3 high on the side. Bad pitting. Don't know what course to follow. I had not planned on a rebore, just clean the block up good, and a real good hone, with new Keith Black pistons, Scat Rods, new rings, bearings etc. All other cyls are fine, just #3.
The pitting is pretty deep, probably .050inch at deepest spot.. I'm stressed out on this, had this block a long time never knew it. Was going to install it in my 66 B-Cuda. Don't have big bucks to play with.
Dave
