Edelbrock 340 heads
Part#60179 I had these heads fully c and c ported by Hughes engines,at that time they enlarged the intake valves to 2.08 and had them mill the heads and enlarge the push rod holes,then a local engine builder installed new 1.60 ex.valves,springs,retainers and 10 degree locks (springs are good to .700 lift)note:these are not new heads they are ones I bought new and used on my 416,but have not been installed since all this work was done.. price is $1750.00 at that price these are a "STEAL" new out of the box(nothing done to them cost over $1500.00 these have over $1500.00 additional work done on them..p.m. or email me..thanks.
Part#60179 I had these heads fully c and c ported by Hughes engines,at that time they enlarged the intake valves to 2.08 and had them mill the heads and enlarge the push rod holes,then a local engine builder installed new 1.60 ex.valves,springs,retainers and 10 degree locks (springs are good to .700 lift)note:these are not new heads they are ones I bought new and used on my 416,but have not been installed since all this work was done.. price is $1750.00 at that price these are a "STEAL" new out of the box(nothing done to them cost over $1500.00 these have over $1500.00 additional work done on them..p.m. or email me..thanks.