Del the (GMC) traitor

-
So cool, you got it. I can hear your neighbors now "here comes that old truck geezer" lol
 
67Dart273 said:
Well, already unbolted the passenger seat, "exploratory" LOL. Explorin lifting the driver's seat that is. I'm 5'11, but I don't like sittin low especially in a pickup. Unfortunately the two front fasteners are studs. We'll see how this goes.

One problem is, when you raise the power seat, only the seat raises, not the back..........so the lumber "thing" gets out of proportion.

With the vast difference in persons, manufacturers should make it easy to block seats up, a kit maybe
Click to expand...
They do make a kit and this one gets very good reviews on the GM truck forums.

SEAT LIFT KIT 2003 2004 2005 Silverado Sierra | eBay
 
^^Thanks I found these as well but am told they will not fit power seats. I will investigate further
 
67Dart273 said:
^^Thanks I found these as well but am told they will not fit power seats. I will investigate further
Click to expand...
It should at least give you some good ideas how to fab your own if you can’t find a kit.

:thumbsup:
 
Ddaddy said:
It should at least give you some good ideas how to fab your own if you can’t find a kit.

:thumbsup:
Click to expand...

Yeh, the quick look I took last night (just unbolted the pass side tipped it fore and aft and looked under) a couple of strips of say, 1" square tube or maybe 1 1/4 would work. Drill "through holes" through the top to get to the bolts below, and offset the seats to the rear enough to get the seat bolts configured.
 
You must log in or register to reply here.
-

Back
Top