amc hemi swap
since i finally got suspension dialed in on the javelin it sits pretty low so i figured id need to get some protection for oil and trans pan . Picked up a remnant 1/4 aluminum plate and worked out pretty good(may weld extensions on each end of skid so they aren't flat ) . Made a tee out of 1/4 flat stock then welded that to my trans cross member . Up front used a piece of 1/2 thick aluminum , drilled 1.25 hole ,cut the hole in half so I could use it as a clamp ,drilled and tapped . Now the tricky part making a removable cross member in between oil pan and trans
since i finally got suspension dialed in on the javelin it sits pretty low so i figured id need to get some protection for oil and trans pan . Picked up a remnant 1/4 aluminum plate and worked out pretty good(may weld extensions on each end of skid so they aren't flat ) . Made a tee out of 1/4 flat stock then welded that to my trans cross member . Up front used a piece of 1/2 thick aluminum , drilled 1.25 hole ,cut the hole in half so I could use it as a clamp ,drilled and tapped . Now the tricky part making a removable cross member in between oil pan and trans
