Distributor lead jumble

synchro66 · May 26, 2019

Have my 360 sb on a test stand after rebuild and it fires up and runs like clockwork, but when i look at the dissy cap the leads look quite messy. Any clues or fixes much appreciated

Dana67Dart · May 26, 2019

I would do this:

Move red lead under coil lead and out between the two as shown

Move green lead as shown.

If only the firing order was different and had the green and red leads swapped

ould do this

RustyRatRod · May 27, 2019

synchro66 said:
Have my 360 sb on a test stand after rebuild and it fires up and runs like clockwork, but when i look at the dissy cap the leads look quite messy. Any clues or fixes much appreciatedView attachment 1715340451

"I" would do AWAY with the 90* boot crap. But that's just "ME".

Distributor lead jumble

synchro66

Well-Known Member

Dana67Dart

The parts you don't add don't cause you no trouble

RustyRatRod

I was born on a Monday. Not last Monday.