I looked for a long time and never found one for my '70 Swinger. Finally ended up using a hood emblem and drilling new holes. Once installed you can't tell the difference
I can't believe they had unique Dodge badges for the front vs. the rear. Unless the rear was slightly small/larger than the front and Chrysler was looking for a poka yoke. But why not commonize? I'm guessing it was one engineer not talking to the other for the hood vs. decklid regarding hole spacing
I purchased a new badge set from Year One, but when the trim guy said the new one did not fit on the decklid, I started looking for a replacement. I was thinking about adding some double sided tape on the area of the badge where the one pin does not locate to the hole and pinning the other end.
