Another 64 barracuda get it going.

Well, here are a few updates. New ball joints, tie rod ends and sleeves, control arm bushings and new strut rod bushings.
time to send it to the alignment shop.
I had a minor fuel leak somewhere in the gas tank, so looking underneath, the sending unit and pick up looked good, no leaks there, so I tried to get a look at the filler spout, hard to tell but nothing obvious there. so I thought I would lower the tank a little bit to get a better luck, as soon as I did gas started pouring out , so drained the tank , then dropped it down to get a better luck, after seeing a problem I know exactly what happened. The trunk filled up with Rainwater, so the bright idea was to put holes in the rubber drain plugs, well guess what , one of those drain plugs is right above the gas tank, so they went through the drain plug and into the gas tank, so they're fixed was to mix up epoxy and fill the hole and the surrounding area. fortunately due to the fact of the age of the tank , I ordered a new tank sending unit and filler grommet.