Motor angle
If you ar wondering how to mount the block to an engine stand and get the correct angle for a 'normal' orientation. I mount mine as shown in the pics. this mounts the engine lower so it isn't so clumsy moving things around.
View attachment 1715355936
View attachment 1715355937
Thank you. Very good pics.
I have mine just "kinda thrown on there" on the engine stand for now. Just a temporary situation for the time being.
I had it in my mind all along to mount the carb base "level"
I just wanted to throw the angle thing out there to see what others thought.
I raced inline 6 (250+ c.i.d.) Chevy motors for years.
Built several "roll / move around" stands for them.
They are quite low. Oil pan only about 3" off floor.
But the way they are made l can also bolt a clutch, bellhousing and tranny to them also if l choose.
Gonna build one, some , a few or whatever for the slants l have as well.
Plus a test / run in stand as the initial post stated.
Thanks again.
