[WANTED] '65 Barracuda center grille section and tail light lenses

-
Status
Not open for further replies.

65cuda340

Well-Known Member
Joined
Nov 18, 2012
Messages
186
Reaction score
192
Location
Madison, MS
Rating - 100%
1   0   0
Contact seller
I am in need of the center section grille and tail light lenses for my '65 Barracuda. I have found one supplier for NOS lenses on eBay, at $350 per pair. Another eBay source offers the pair for $49.99, but cautions that they are made in Mexico, might have a different tint, and are only driver quality. I will cough up the $350 if necessary, but was just wondering if anyone is aware of a good source that might be a little cheaper. I have been unable to locate a source for the center grille section; again, I need something in new condition, not driver quality. Any leads will be greatly appreciated.
 
I “think” I have a pair of NOS lenses w/o boxes. To my knowledge they are NOS, not Lawson’s repro’s or made in Mexico, Taiwan, or mainland China. Let me find them and take some pics.

EDIT: PM me if interested
 
Last edited:
I “think” I have a pair of NOS lenses w/o boxes. To my knowledge they are NOS, not Lawson’s repro’s or made in Mexico, Taiwan, or mainland China. Let me find them and take some pics.

EDIT: PM me if interested
I tried to send you a PM, but got a message that your inbox is full, so I can't start a new conversation. I'm probably doing something wrong, but I am definitely interested.
 
Sema this year? I will be there....
It's getting close, but I think I'm going to make it!
2019-02-25 5.JPG
 
It's getting close, but I think I'm going to make it!View attachment 1715360726
Hope it does, give me something to drool over, and make me sad at the same time. Something i could never accomplish if i had 20 years. Looking great.
My wife was asking if i knew anybody attending sema. I do now!
 
Hope it does, give me something to drool over, and make me sad at the same time. Something i could never accomplish if i had 20 years. Looking great.
My wife was asking if i knew anybody attending sema. I do now!
If it makes you feel any better, I have had it since 1977; ran it with a 340 until 2015. It now has a full frame, independent rear suspension with Moser center section and differential cooler, Detroit Speed front suspension, 433 cubic inch aluminum 3rd gen Hemi with Hilborn stack injection and dry sump oil system, Tremec 6-speed with sequential shift conversion, Viking active suspension control, and a few other goodies. Here is the rendering, from Hot Rod Chassis and Cycle:
CF1 rendering.jpeg
 
I tried to send you a PM, but got a message that your inbox is full, so I can't start a new conversation. I'm probably doing something wrong, but I am definitely interested.

I just check my PMs and have 227 out of the 1000 slowed for a Gold Member. I haven’t had a chance to get to my storage today but will try tomorrow
 
I just check my PMs and have 227 out of the 1000 slowed for a Gold Member. I haven’t had a chance to get to my storage today but will try tomorrow
Well, I just found a very straight grille on eBay, and jumped on it immediately. Looking forward to seeing the pics of your lenses!
 
If you’ll clear a few message from your in box, i’ll Send you some pics.
 
Status
Not open for further replies.
-
Back
Top