Cone Sure Grip Resurrection

Aight den. We all know this story, so we're not hashing back through "that" again. That's not what this thread is about. I have instructed the moderators to dump any off color comments, so if you have nothing to say positive regarding this, then shut up. This is to make sure @63spf ends up with a good, workable cone type sure grip unit. Here are all the parts I have received from Chris, @63spf, Bob, @Bigboy 68 and Jim, @fratzog lover. I have some parts of my own that are not in the picture, but I will take from those if necessary.

So far, we've gotten lucky. I was able to successfully press the small spider gears off the cross shaft that @fratzog lover, Jim sent. They both have great gear teeth and only minimal pitting on the inside bore. All I need to do is hone them out with a brake cylinder hone, as they did pick up some metal from the cross shaft, but they will clean up nicely. Follow along if you want to. This won't take to long now. Here is what I have. Unusable parts on the right hand side.

SURE GRIP PARTS.jpg