[FOR SALE] Slant Six Camshaft

-
Status
Not open for further replies.
RustyRatRod

RustyRatRod

I was born on a Monday. Not last Monday.
FABO Gold Member
Joined
Jun 7, 2010
Messages
104,723
Reaction score
102,221
Location
Georgia
Rating - 100%
72   0   0
Contact seller
After much figuring with the slide rule and the abacus, I have determined this camshaft is too small for my build, so I am going to sell it. It's a solid flat tappet from Hughes Engines.

It is this one:

Hughes Engines

I am going to have too much static compression to run this cam so I need a different one. I've only had it out of the box twice. It's never been in a block. Located in middle Georgia, I will take 150 shipped to the lower 48.

Thanks.
 
This cam will work fine if your using stock type slant six pistons. It will not work for my build because I am using the long 198 rods and 2.2 non turbo pistons. It would also work if you are using the long rods but with the turbo pistons.

Still for sale.
 
Status
Not open for further replies.
-

Back
Top