Trim Cip ID?, maybe 67 Dart Lower Sill Moulding

-
Hyper_pak

Hyper_pak

Old School Chrysler Fan
Joined
Feb 14, 2010
Messages
4,692
Reaction score
5,879
Location
Desoto Texas
I don't have the car or the molding, but I do have 7 clips. I think they are 67 Dart Lower Sill. Here are some pictures, anyone positively ID these? There is a rubber soft bushing in the center of each one. P1430 is stamped as shown. Any help is appreciated!
IMG_9926.JPG
IMG_9927.JPG
IMG_9928.JPG
 
Not 67 dart gt rocker molding. My guess.. they are a fender top edge or trunk clip by the bend in them.
 
Thanks dana67dart, I really don't know now. I am sure someone needs these!
 
Not trying to hijack post just helping to clarify...

67 Dart GT rocker trim clip
rocker clip.jpg

67 Dart GT trim that runs along top of fender door and quarter.
trim clip.JPG
 
Can you get some close ups of the rubber part and post it. when I put my rocker clips on they did not want to stay in on their own and if there was supposed to be a rubber insert over the fingers that would make sense on how they would hold on and seal. I always thought it was a dab of body putty in the hole with the fingers.
 
I will post that for you tomorrow. These clips were in with those upper plastic clips you posted, had about 5 of those, I know how hard those are to find and how the plastic keeps the trim off the paint. Thanks for posting the sill clips, I remember seeing those also. I think they went with the GT I sold years ago.
 
Those rocker panel clips yep rare as rocking horse doo !
 
Here are some pictures of the rubber insert. I think these are molded, looks like a small wafer and then the rubber part. It snaps on the raised tabs. Hope this helps.
IMG_9940.JPG
IMG_9941.JPG
IMG_9943.JPG
IMG_9944.JPG
 
Thanks for the photo, I had no Idea! I always thought there was a spot of dumdum on them now it makes sense.
 
You must log in or register to reply here.
-

Back
Top