Dana 60

I haven’t needed a case spreader. I can make one for sure. I know it can’t be spread more than .015 I use a rag between the ring and pinion to dislodge the carrier. Then, a few whacks on a 2x4 under the ring bolts and the inside of the spool and it’s out. I found that the only trouble I have reinstalling it is if the bearing cups are cocked. But that isn’t my question. Like I said, I’m trying to find where the FSM starts. I made some tester bearings and cups to make it easier to dial it in. I still haven’t checked the newest combo of shims, it was getting late and I was tired