How would you build a low 10’s street car

Here is a short list of what I can think of off the top of my head of what is in my 10 second street car....

67 Barracuda, 3250 lbs in street trim…..

· 360 block, 4” Scat forged crank, Scat I-beams, Icon forged flat top pistons, ATI balancer
· Ported Edelbrocks, 57cc, Comp Pro Mag rockers, Smith Brothers oil through custom pushrods
· Hughes solid cam 264/268 @ 0.050, ~ 0.620 lift, Howards EDM direct lube lifters, PAC springs
· 13:1 compression, Holley XP 950 e85 carb, Victor intake (port matched), super sucker
· MSD distributor, coil, and 6AL box, NGK R5671A-7 plugs
· 1 ¾ Headman Hustlers headers
· 727 race trans w/ manual valve body (turbo action), bolt in sprag, 8” PTC converter
· 3” exhaust with Dynomax race bullets
· MO875 rear end, back braced, 35 spline axels, spool, 4.10 gears
· Weld Draglites with Hoosier drag radials (275/60/r15)
· Full Caltrac setup (mono leafs, link bars and shocks front and rear)
· Mini tubbed, frame connectors, roll cage, 4 wheel disc brakes
· Becool radiator, 2007 Chevy HHR fan
· Racing seats, belts, gauges, aftermarket shifter, fuel cell (and building a rear fire wall), battery relocation kit, Holley Black pump

I'm sure I'm forgetting a lot of stuff...but I'm at work, and this is all I could think of off the top of my head. As you can see, a lot of expensive parts...plus you need the know how of what to do with said parts, and the know how of how to tune the car (as a whole) to make it run well.