MSD Ready to Run wiring question
Good evening, y’all
I’ve been rewiring my 72’ Duster using a KwikWire budget kit for a couple of months now and I’m seeing the light at the end of the tunnel. I saved the ignition portion to last because I knew it was going to be the trickiest. I’m trying to install using MSD’s Ready to Run distributor and I think I have a lot of it figured out but I’m still fuzzy on other things. Tell me if this diagram makes sense to anyone else and what do I need to do to finish it up.
1. The blue wire on the voltage regulator, what happens with that?
2. There is a white wire here from the KwikWire kit marked “alternator exciter” what should I do with it?
3. Should I be bypassing the starter relay and going directly to the MSD start cable?
I’m confused! Help me gentlemen!!
Good evening, y’all
I’ve been rewiring my 72’ Duster using a KwikWire budget kit for a couple of months now and I’m seeing the light at the end of the tunnel. I saved the ignition portion to last because I knew it was going to be the trickiest. I’m trying to install using MSD’s Ready to Run distributor and I think I have a lot of it figured out but I’m still fuzzy on other things. Tell me if this diagram makes sense to anyone else and what do I need to do to finish it up.
1. The blue wire on the voltage regulator, what happens with that?
2. There is a white wire here from the KwikWire kit marked “alternator exciter” what should I do with it?
3. Should I be bypassing the starter relay and going directly to the MSD start cable?
I’m confused! Help me gentlemen!!
