The 70 340 duster getting terminated
I don't know if any of you know this but early 70 and late 70 are different fenders. The late 70 fenders take the same headlight rim Grommets are the same as 71 .
The early fenders take a shorter grommet because the square hole is a 1/4 inch closer to the front of the fender.
Now I know some of you would call me out so I thought I better take a picture . If you have a early fender and need a grommet you will have to cut 1/4 inch off of a later one and counter sink the end with a counter sink bit. They are the same as a 69 grommet.
One other thing is the 71 has the hood pin access square hole. 70 Dusters never came with hood pins from the factory. the pictures will tell the story.
The access hole for the pin gets a special nut with a plate to be used for easy adjustment and assembly no wrench neede on the bottom nut. If you look close at the last picture I copied and pasted you will see the plate that is fastened to the factory nut that protrudes though the hole. There is a bend in the plate. I have the nuts if you want pictures.
I don't know if any of you know this but early 70 and late 70 are different fenders. The late 70 fenders take the same headlight rim Grommets are the same as 71 .
The early fenders take a shorter grommet because the square hole is a 1/4 inch closer to the front of the fender.
Now I know some of you would call me out so I thought I better take a picture . If you have a early fender and need a grommet you will have to cut 1/4 inch off of a later one and counter sink the end with a counter sink bit. They are the same as a 69 grommet.
One other thing is the 71 has the hood pin access square hole. 70 Dusters never came with hood pins from the factory. the pictures will tell the story.
The access hole for the pin gets a special nut with a plate to be used for easy adjustment and assembly no wrench neede on the bottom nut. If you look close at the last picture I copied and pasted you will see the plate that is fastened to the factory nut that protrudes though the hole. There is a bend in the plate. I have the nuts if you want pictures.
