Decent cam for 360?

4geardemon said
I have this bone stock 72 360. I would like to wake it up slightly. It purpose down the road will be sliding into a truck and hit the quarter.
What would be a decent cam choice for the stock compression?
I ran across an Edelbrock performer rpm intake for stupid cheap. So I plan to swap the stock intake for this one. I have an 800cfm Holley sitting on the shelf. Could this be detuned enough to not big too large for the stock specs? I am just trying to work with what I have.

Any help is appreciated!!
Click to expand...

I have used the below cam in stock compression 318's and 360's before with good results. The wider centerline/reduced over lap and mild duration numbers will wake up the ride a bit and you will not need a aftermarket converter. Purchase the matched springs with it. The 800 cfm carb can be jetted down, not detuned, jetted down, to use. I'd rather a 600cfm at the smallest and a 750cfm at the largest.
Crane Hydraulic Flat Tappet Camshafts 693941