ProComp/Speedmaster aluminum heads

j par said

it's been over 3 weeks since we seen the pictures of the rusty Dusty R Block laying on the floor any progress? now that the ultimate bench racer has spoken This Thread is doomed to go to crap now! Snowmobile? Definitely don't bring up the Exxon Valdez... I'm never I mean never ever bring up the word time slip around yellow rose!!!...

Correct ones balls must be kicked hard for such an interruption...

again my most sincerest apologies there's no way the ultimate bench racer is going to come in here and poke at me and not get one hell of a jab back...

Click to expand...

Not ready to start on it yet. Already know what piston I need. Now I've got to sell one set of rods and buy another. Then I have to find out about valves. Going with .312 stems (I don't do metric) and I need to see what I can get with a 1.500ish for the exhaust and 2.050ish for the intake. Then I need to do some research into the cutters I want to cut the seats. I may use the cutters I have...or I may try a different cutter that's available, or...I may sit down and design my own cutter, depending on what the bowls look like with those valve sizes.

I'm not even going to PDX before December 3rd so nothing big is going to happen before then.