1963 Dodge Dart 270 Convertible for the Wife
Some after work... work.....
Opened up the cracks with various size Dremel ball grinders, depending on the size of the crack. Then drilled holes at a 45 degree angle in the walls of the cracks to allow epoxy to flow into the holes to grab the sides better. Mixed up some PC7 and worked it in with wooden tools. Not sure if I like this better than JB Weld for flowing into the cracks and voids.... I do like that it does not flow everywhere.... I hope this works well other have used PC7 successfully....
I then wrap it with tape so I can press down and get a smooth surface on the epoxy and hold it in place so it won't flow. The tape glue won't stick to JB Weld so I am hoping for the same with PC7....
Some after work... work.....
Opened up the cracks with various size Dremel ball grinders, depending on the size of the crack. Then drilled holes at a 45 degree angle in the walls of the cracks to allow epoxy to flow into the holes to grab the sides better. Mixed up some PC7 and worked it in with wooden tools. Not sure if I like this better than JB Weld for flowing into the cracks and voids.... I do like that it does not flow everywhere.... I hope this works well other have used PC7 successfully....
I then wrap it with tape so I can press down and get a smooth surface on the epoxy and hold it in place so it won't flow. The tape glue won't stick to JB Weld so I am hoping for the same with PC7....
