Can’t figure out carburetor

Murray said
Idle mixture screws out of adjustment will not prevent the car from starting. If carb is flooding, then check the float level. Have you removed the distributor? 180* off?

When setting the timing, I made sure the rotor was pointing towards the #1 cylinder. I’ll check float level when I get home tomorrow and find the book that came with the carb.

yellow rose said
That's too much fuel pressure. Cut that down to about 5 psi and that's a start. Get your initial up to 18-20 degrees and then you can start tuning.

What cam, ignition and pugs are you using?

Assuming I need a fuel pressure regulator to do that unless there’s some trick I don’t know.
Cam specs posted below
I a Summit brand electronic ignition system just like the factory style that came with my 440, and an MSD coil.
I have a German Shepherd not a Pug. But my plugs are E3 (I have them in all of my vehicles)