Barracuda tail light swap
Heres the idea. Not getting too far into it since I like to think stuff through. Chew on ideas as I get started. Plan is this, it screws on with plate over it using bottom screw holes in the valance. I will attach a ground at licence plate mount, and run one wire inside using licence plate light grommet and tie it in there. Top of plate tucks inside the slot allowing the light to sit half over the top edge of the plate. I may likely trim it down even further. Have not decided yet.
Heres the idea. Not getting too far into it since I like to think stuff through. Chew on ideas as I get started. Plan is this, it screws on with plate over it using bottom screw holes in the valance. I will attach a ground at licence plate mount, and run one wire inside using licence plate light grommet and tie it in there. Top of plate tucks inside the slot allowing the light to sit half over the top edge of the plate. I may likely trim it down even further. Have not decided yet.
