HEI Upgrade but No Spark (kinda)
So I was able to test the two wire connector from the distributor to the HEI module and there are no issues there.
Was also able to test for voltage at the coil in the run and start positions-have voltage in both positions but just tested with a light-need to test for voltage but my multi meter is DOA.
So here is what interests me-I used this diagram when wiring things up. But I have seen other sources that show a different wiring.
This diagram shows both ends of the coil going to the B side of the HEI module.
But I have seen other wiring diagrams with the B side going to coil positive and ignition run while the C side is coil negative and tach.
Can this setup run with both coil + and - going to the B side of the HEI module?
So I was able to test the two wire connector from the distributor to the HEI module and there are no issues there.
Was also able to test for voltage at the coil in the run and start positions-have voltage in both positions but just tested with a light-need to test for voltage but my multi meter is DOA.
So here is what interests me-I used this diagram when wiring things up. But I have seen other sources that show a different wiring.
This diagram shows both ends of the coil going to the B side of the HEI module.
But I have seen other wiring diagrams with the B side going to coil positive and ignition run while the C side is coil negative and tach.
Can this setup run with both coil + and - going to the B side of the HEI module?
