67-69 Dart Convertible - Foam Seal Between Rear Tack Strip and Body

Dana67Dart said

I did and he is super nice. It seems that the set he sells is based off 67 Barracuda. It would appear that they are not the same as Dart.
He even offered to refund my money which I refused.

I measured up my foam and tack strips and sent the dimensions to him.

He offered to buy my OEM foam but I want to keep it for now.

Really a good guy!

Click to expand...

I second all the positive things said about DMT and Mike. Not surprised at all.
I'm in Ohio and he is always at the Mopar shows. One time I had pre-arranged to pick up a /6 bell housing from Brewers at the show. I needed the rubber bellows/seal that fits around the clutch firk and he had them. I told him I'd buy one and check the fit on the BH I had in my trunk. He wouldn't take any money up front. He said go try it snd come back.
It fit and was a LOT better quality than the thin one I had bought from another vendor for my 3 speed BH that lasted all of 100 miles. It had gotten sucked inside and got shredded by the spinning clutch inside.

Talking to him several times I know he is committed to producing the best parts he can.