Very kind of you Al, but that’s ok. I haven’t inspected mine. But, I’m close to doing so. Mine more than likely is fine. But, I was hoping to replace it with new while I’m into this project, this far. They easily slip off after you remove the C-clip retainer that holds it in place. I found through research, before you replied. That they have been extinct since 1988. You can’t buy them new, bummer. The oddest part of that. You can buy a 727 bearing new. They both have the same exact retaining groove. But, the 727 bearing is very slightly bigger in diameter. Unless, I find out mine isn’t good as I had hoped. You better hold onto them. You’re a good man, Al