balance ?

Oldmanmopar said

You cut through the hardness of the crank good luck keeping bearings in it. They will stick fast like an Alabama tick when they get heat in them. Buy a crank or pay to get it cut then rehardened and balanced for more than the cost of a new stroker kit.

Click to expand...

I'll more than a little puzzled by this.......I have never heard of thru hardening a cast crank.......I'm not even sure if it is possible.....only crankshafts that were hardened to my knowledge were Hemi, 318-3 truck engine crank, and they were only surface hardened, first .010 cut on the crank removed the hardened materail