[FOR SALE] 8 3/4 Brass Brake T Fitting & Vent Tube $18 plus shipping "

-
Status
Not open for further replies.

gregpurcell

Greg Purcell
Joined
Aug 21, 2008
Messages
2,052
Reaction score
221
Location
Near Savannah, GA
Rating - 100%
31   0   0
Contact seller
After a few requests I've finally cleaned up some of my used 8 3/4 brake line fittings. They are brass and polish up very nicely on the wire wheel. After that, I clear coat them to keep them that way. I also have the special vent bolts that have a "check valve" in them.

This is the fitting that bolts to the 8 3/4 housing. The rubber flex line goes in one side and the two steel lines that run across the tubes of the rear to the backing plates go in the others.

There were two types, a "Y" fitting that was used up to 1970 and a "V" on 71 and 72.
They are interchangeable if you are bending new lines.

Dr Diff sells these new for $18 for the block and $18 for the bolt. I'd like to get $18 for the pair plus shipping from Savannah,GA which is $8 in the US.

This sale is for ONE SET either the "V" on the left or the "Y" on the right in the picture below.
Merry Christmas & Thanks for looking!

DSC04386.JPG


DSC04387.JPG
 
.I have one good vent bolt and three brass fittings left (one "Y" and two "V") I also have a number of vent bolts that don't have the "check valve" working or the top cap is missing. These would attach the brass block to the rear and vent the housing if you were not picky. So any one block with the good bolt is $18 plus the ride. A block with the open bolt or NO bolt is $10. (bad vent bolts are free with block) $30 gets you everything I've got left (PM for pics)
 
Status
Not open for further replies.
-
Back
Top