Cam grinder/manufacturer opinions

12many said

Decided on an UltraDyne lobe N57, single pattern [email protected]”,[email protected]”, 282adv @.020”, .388” lobe (.604” after lash w/1.6 rocker) on a 106lsa, likely install at 100 icl. Same as offered by Lunati but on a 106 instead of their 108lsa/102icl, same as was spec’d originally by Brookshire/Ultradyne. Put on a 106......cause that’s what I wanted.

Click to expand...

LOL. Pretty freaking cool.

That's essentially the same lobes I'm using. I lash at .014/.016 hot. And I'm on a 105 in at 105.

So.....even though are lobes are so similar as to be the same lobes, the two cams will act differently because of the LSA and ICL differences between the two.

That's why a custom cam is always better. Until you get your cam card and get the actual events can we see the real differences.

I think you'll be very happy with that lobe. It's about a Comp MM series lobe. And the LSA will make it a neck snapper in the mids.

This should be FUN.

Edit: forgot to mention I'm digging the single pattern too. I'm sure the lash difference between the intake and exhaust will change the timing a bit, but you didn't open up the exhaust and reduce intake timing and open the LSA to get the RPM back.

Very cool.