Cam grinder/manufacturer opinions

yellow rose said
LOL. Pretty freaking cool.

That's essentially the same lobes I'm using. I lash at .014/.016 hot. And I'm on a 105 in at 105.

So.....even though are lobes are so similar as to be the same lobes, the two cams will act differently because of the LSA and ICL differences between the two.

That's why a custom cam is always better. Until you get your cam card and get the actual events can we see the real differences.

I think you'll be very happy with that lobe. It's about a Comp MM series lobe. And the LSA will make it a neck snapper in the mids.

This should be FUN.

Edit: forgot to mention I'm digging the single pattern too. I'm sure the lash difference between the intake and exhaust will change the timing a bit, but you didn't open up the exhaust and reduce intake timing and open the LSA to get the RPM back.

Very cool.

Yup, Comp, Lunati, and Bullet all the same lobes essentially from what I could see. The hotrodding around I do on the backroads/interstate is usually smack dab just at/in the mid range, lot of fun now, should be white knuckle fun soon! I don’t ring it out on the road or do from a stop blow the tires off launches, and as long as I can keep it hooked at the track as it does currently, usually jumping out in front of the other guy only to be out run by the hotter camarllangerststangs, now I hope for even more jump and actually pulling away from them on the top end. Will see.