How do I replace these metal pieces from my instrument panel?
found one problem on the left side///broken power feed pins on the circuit board
used solid copper buzz wire pre tinned everything// used a fiberglass pen to clean everything //soldered everything //checked , bulbs and board for continuity //cut pigtails off of the back,used a dremel tool to sand the backs of the pins flush with the board an a piece of gorilla tape on the back to keep the back from shorting out on the cluster frame.
stronger than factory !!!!!!
found one problem on the left side///broken power feed pins on the circuit board
used solid copper buzz wire pre tinned everything// used a fiberglass pen to clean everything //soldered everything //checked , bulbs and board for continuity //cut pigtails off of the back,used a dremel tool to sand the backs of the pins flush with the board an a piece of gorilla tape on the back to keep the back from shorting out on the cluster frame.
stronger than factory !!!!!!
