Even though most of the emphasis has been on the exterior, I can’t forget about the interior. I used the upper door sill from the rear doors on each side to give it some continuity from the front doors to where it continues over the wheel wells. Where the rear door skins are mounted, I made a somewhat oversized paper pattern of the opening and copied it to sheet metal. Prior to the start of the installation, I also cut out each panel for the new Pioneer 6x9 speakers I’ve had forever. I’ll use nutcerts to secure the speakers after the interior gets painted. Then it was cut and fit, punch holes around the perimeter to spot weld each one in place. I still need to do the upper inside, which I’ll do after I receive my new 3 point seat belts.
Driver’s side:
View attachment 1715456897
Passenger side:
View attachment 1715456898
Brand new speaker(s):
View attachment 1715456896
