46re Trans Swap

TT5.9mag said

@indirect_connection, you have to install resistors in the harness to simulate the load caused by the fuel injectors. You have to trick the jtec controller in to thinking it is still controlling everything.

@TrailBeast, do you know of any other standalones than the one I posted?

Click to expand...

I looked into them when I did my 42rh swap, but they were not cost effective in my case because of the hydraulic controlled trans.
It was way better for me to build a pressure controlled system for shifting, so I didn't spend a lot of time on the electronic controller stuff.
Just knew that some were out there.