Project Frog Princess
The engine checks out nice.
Bores within .004, could be DIY honed and run but it’s going .030 over for the stroker kit.
Crank end play and one main bearing measure in tolerance.
I saw bearing material in the pickup so was expecting worse.
Something scored the lower nongrooved half of the rear main and went on its way out the groove with no other visible damage. Crank looks fine.
Would not matter since these parts will be replaced but kinda interesting.
The engine checks out nice.
Bores within .004, could be DIY honed and run but it’s going .030 over for the stroker kit.
Crank end play and one main bearing measure in tolerance.
I saw bearing material in the pickup so was expecting worse.
Something scored the lower nongrooved half of the rear main and went on its way out the groove with no other visible damage. Crank looks fine.
Would not matter since these parts will be replaced but kinda interesting.
