Fender top turn signal

-
Yote

Yote

Well-Known Member
Joined
Aug 30, 2015
Messages
1,404
Reaction score
730
Location
far eastern Colorado
Re: 1972 Demon
Wanting to add fender top turn signals. Does anyone have the dimensions to properly place them to match factory specifications.
Yote
 
I could give you dimensions off a duster fender but might be a little different than a demon due to the front fender/filler panel difference.
 
Do you actually like them or are you trying to make it OEM resto type of deal.
 
Like the look of them and though they were not origional to this car I want it to be correct. Just have to install and plug in.
PO installed different hood with twin scoops instead of original snorkel and not numbers match engine So adding these should not detract from what the car could have been from the factory with other dealer available added options.
Yote
 
Did you ever find the hole locations? I put AMD fenders on my demon and didn't realize they weren't in there before I got rid of the others. Duh!

Thanks, Carl
 
Unfortunatly there is no factory template available because the fender holes were done at the stamping plant . I'm afraid that you will have to measure yourself or make your own template from an existing one .
 
Gotcha. Maybe someone could pull some rough measurements for a general area. Either from the light itself or the actual holes.

Thanks again!
 
You must log in or register to reply here.
-

Back
Top