71 demon fender mounted turn signal location

-
deviledchin

deviledchin

FABO Gold Member
FABO Gold Member
Joined
Mar 15, 2012
Messages
511
Reaction score
172
Location
Sellersville,Pa
So I bought AMD fenders and didn't notice that the holes for the fender mounted turn signals are not in the panel. I got rid of the original ones I took off before I realized they weren't in there. Does anyone have hole locations that they could post? It's a 71 demon

Thanks in advance,
Carl
 
Here ya go

15810903428731136413027371130345.jpg
 
deviledchin said:
So I bought AMD fenders and didn't notice that the holes for the fender mounted turn signals are not in the panel. I got rid of the original ones I took off before I realized they weren't in there. Does anyone have hole locations that they could post? It's a 71 demon

Thanks in advance,
Carl
Click to expand...
Hey Carl I have a 73 Scamp with the top lights not sure if it's the same but if you need I can get you some pictures and measurements.
 
Thanks guys! Yeah I just need measurements. Possibly from front of fender to the holes and possibly a center line off of the drop to the inner fender.

Thanks, Carl
 
deviledchin said:
Thanks guys! Yeah I just need measurements. Possibly from front of fender to the holes and possibly a center line off of the drop to the inner fender.

Thanks, Carl
Click to expand...

There are two different indicators.
The early (72) uses just one hole and the other needs two. (one for the bulb section and one for the mounting screw.
The early indicator is mounted with a nut from underneath, and the later uses a screw in from the top.
The early indicators are also smaller than the later ones.
 
20200207_100801.jpg
20200207_100815.jpg
20200207_101022.jpg
20200207_100327.jpg
That's mine any way Original fenders so factory holes. Hope that helps Carl.
 
TrailBeast said:
There are two different indicators.
The early (72) uses just one hole and the other needs two. (one for the bulb section and one for the mounting screw.
The early indicator is mounted with a nut from underneath, and the later uses a screw in from the top.
The early indicators are also smaller than the later ones.
Click to expand...
TrailBeast I think your one of the few here that has so much knowledge, glad your here to help.
 
I have the type w/o the screw like mtrhead posted, but I'll take a look at to see how close both photos come on the fender.

Thanks!
 
deviledchin said:
I have the type w/o the screw like mtrhead posted, but I'll take a look at to see how close both photos come on the fender.

Thanks!
Click to expand...

I just looked at the 72 Dart and it has one hole for the light/wire, and a locating pin on the indicator.
Two holes like mtrhead posted.
Since the indicator is on the car I can't get an exact for you, but since I F'ed up on the holes I went out and measured where the light fixture itself is.
1 and 5/16 from the fender extension seam to the tip of the fixture.
13/16 from the hood side fender edge.
 
Last edited:
You must log in or register to reply here.
-

Back
Top