massive reconfiguration time again.

Cope said

Are your fuel inlet into the carbs "standard Holley thread?"

Not sure if im going fishing or going to work in the morning but when i get to the shop i will look and see what i got.

I know i have some of the carb fittings, tube nuts, sleeves and male swivel 90s.

I just gave away a full roll of -6 hard line but id bet i can make you a decent care package.

I just need to know what thread your carb inlet is, i will box you up some stuff and send it your way.

Click to expand...

The carb boss is 9/16 by 24 thread that uses a thin crush washer.. the fuel rail has 6an female swivel fittings... I'm just afraid that it's all going to run into the nitrous solenoids that will likely be on that side as well... With all the linkage and everything on the driver side I just don't see the solenoids being able to go over there.. I really need to get my 90 degree female to male 6an adapters to get out of between the carburetors and get the solenoids mounted up so I really know where everything is going to be at..