Fan clutch bushing question

71DodgeDemon340 said
It mates to the pulley but if you lay the fan clutch face down on the table and put the brass bushing in the pilot hole you can see the brass bushing sticks up some from the fan clutch, if you set the pulley on the fan clutch shaft the brass pushing allows the pulley to rock back and forth
Click to expand...

Is your setup similar to this one?

This pic is of my old clutch fan setup prior to replacing the rad and going with the Compact Hayden 2765.

If I recall on mine I thought that the bushing was actually a little too short and I installed it on the shaft and then mounted the clutch fan.

69'Cuda Unmothballed OEM Rad 12.15.19-7.jpg 69'Cuda Unmothballed Radiator 1.19.20-3 (2).jpg