Nitrous plumbing A1A...??..

So I'm scratching plan A as far as where my houses are routed. I was going to do one short and one long for the fuel and the same for the nitrous. I did some measuring and I'm going to order two new 14 inch houses with 90-degree elbows for the front and the back of each carb coming from the farthest reaches to the center on the passenger side..
I'm also ordering four 90-degree elbows two of which I need to have to get out from in between the carburetors and then I'm going to use the shorter provided hoses with the plates to elbow back into the fuel side solenoid on the driver side.
It's been mentioned a couple times that people like to route a little bit longer hose for the nitrous as it introduces a softer hit instead of abrupt...
I cut some 14 inch vacuum lines to simulate...