Project Frog Princess
The engine is at the machine shop. Block checked out good. It's getting .030 over and line bored.
So I decided to inspect the A833 OD.
I started out thinking having it on an engine stand would be nice, but it's better on a bench.
I'm not sure I will bother to disassemble any further as everything is looking quite pristine.
Just have to double check the countershaft case holes but I think they are fine.
I considered having them sleeved, but decided against it, as long as they are in good condiiton.
I have to come up with an arbor shaft / dummy shaft for assembly. I have the Passon book but its lacking on suggestions for this.