I have a complete set of stamped stock rockers, they have been cleaned and are ready to be re-installed they have minimal wear it includes all necessary hardware including rockers, shafts, stamped hold downs and spacers.
I am asking $25 plus the ride. ---PRICE REDUCED---
The rocker shaft hold down bolts were sold.
I also have a set of Harland Sharp stainless steel hold downs for the big block Mopar‘s. These were used only for mockup I am asking $75 plus the ride they are $95 on the website. ----SOLD----
I have a set of manton pushrods they have a ball on both ends.Overall length is 9.90 5/16 diameter, I used these for break-in only. These were about 200.00 new asking 75.00.
I am asking $25 plus the ride. ---PRICE REDUCED---
The rocker shaft hold down bolts were sold.
I also have a set of Harland Sharp stainless steel hold downs for the big block Mopar‘s. These were used only for mockup I am asking $75 plus the ride they are $95 on the website. ----SOLD----
I have a set of manton pushrods they have a ball on both ends.Overall length is 9.90 5/16 diameter, I used these for break-in only. These were about 200.00 new asking 75.00.
Last edited:
