Start of a Dart

Slow progress but the weather here has been real nice the last few days so I decided to tackle an outdoor project while it was relatively warm and sunny. The PO was said to have sanded down the original F3 green paint and re-primer it in yellow (?). Getting a better look at it I think it was just painted over. Lots of runs and flaking off the old paint. Much of the car was sanded down to bare metal and left to the weather so it was rusted in many spots. I was pushed for time, so I gave it a quick sand job to take off the worst of the rust, wiped it down, and primed as much as I could. I left the fine-detail stuff for later like around the rear window. That area will take a lot of masking but I can do that inside later on.

The good news, I just got this done before it was too cold to rattle-can it. The bad news, my highly questionable wiring is acting up again and I have no spark so the car is stuck outside in the driveway. :BangHead:

(Sigh). I will be calling my neighbor to bring his tractor over and push this back in the shop where I will sort out all the mysteries awaiting me.

I see the possibility of a complete rewire in my future. Looking at the cobbled-together mess under the dash and hood, it might be easier to just rip it all out and start over.

DSCN0088.JPG

DSCN0089.JPG