Has anyone successfully used the USCartool A500 Crossmember?

plumkrazee70 said
Right. Should I wait until the Driveshaft is made before welding that tab on? What the beat way to check the angle?

I made my car level by putting a level on the rockers, then jacked the trans so it was pointed on the rear. I then just used a harbor freight $4.95 angle finder and placed it on the end of the trans. It was 4 degrees down, I adjusted it to five degrees down figuring it was easier to add a spacer to lift up that to re-cut to move down.
This may not be the ideal way, or correct way, but it worked.