Long valves on W2's with .600 lift?

Krooser said
Happy now... I think this will put us in the ballpark.

I think we'll try intakes first. Cost is $584.00 for the intakes only. I can send in my 1.5's and T&D will change them over to 1.6's and I'd save a few $$$ but I'd sooner have them as backups. I can always buy the exhaust rockers later and put a full set of 1.6's together as my budget allows.

Headgaskets... used 1008's before but I don't like the 4.1+ bore size. Cometic has a .027 thick, 4.040 bore MLS (same as the block) gasket... opinions? Compression with the 1008 was figured at 13.5...

I'd like to try Superformance gaskets for the balance of the build. Never used them but there are lots of good comments and I like dealing with smaller comapnies.

Use the cosmetics. Hard to beat those.

I will never use another gasket form anyone other than Superformance unless Superformance doesn't make them.

His gaskets are so good it's a shame. His carb gaskets are second to none. Period. And the rest of his stuff is just as good.

If you order directly from him, remember he is a one man band. He makes the gaskets, does the packaging, does the shipping, answers the phone and everything else. If he doesn't answer, leave a message and he will call you back.

I can't say enough good about his gaskets AND he is a Chrylser guy.