$50? Mine were $8 a side! I bought the 1X3 11G steel rectangular tube by the .lb out of the metal supply scrap bin. Cut, welded a front butt plate at the end and tied other into rear subframe on the 65. I can jack up the car behind the front tire and the rear will come up the same height as well as the door alignment not moving at all even when opened. Couldn't see that without them installed. I tacked the bar every place I could into the floor pan, about 5 places but couldnt stitch the entire length as the floor is not flat and I didnt want the bar to enter the interior.