Budget Rocker choice

mopowers said

Tell that to everyone who's been running aftermarket rocker arms without any fancy geometry correction kits with zero problems. Sorry - not buying it! Actual empirical data would be useful for your argument. Anecdotal **** doesn't cut it. We need numbers.

Click to expand...

I didn’t give you anecdotal ****. I’ve been doing this **** since 1980 so ive lived it.

And then people like you, who claim your junk runs fine, who have never seen a dyno or had an engine on a dyno tell everyone that geometry correction is a waste of money. That is straight ignorant.

Mike just laid out the math. Even you should get that.

It used to be the only way to fix this junk was to mill the stands and use offset shafts and stands. It was expensive and most guys passed on it, with the results you don’t believe above.

Now, the way to fix it is very economical to correct it. But your no experience *** feels like you need to run into every thread and tell everyone how your **** runs fine with junk geometry.

Some day, when you discover how ignorant that is, you will correct your geometry.