Nitrous plumbing A1A...??..

SUCCESS!!!
Nitrous, fuel, and purge solenoids functional!!..
I blipped the fuel pump on for a sec and made sure it has power but I couldn't run it because there's no fuel in the system..
I jumped the low pressure switch which is the ground for the relay. I turned on the arming switch and had my wife hit the button on the shifter. And then by hand clicked the full throttle switch and both solenoids clicked... The purge solenoid was just a matter of hitting the button..
I did have an initial set back as I turn the power on nothing happened!???.. I had set my wife back into the house and said I'm going to have to check things out so I started at the beginning and bingo! I didn't put a fuse in the main feed line back by the cut off switch... LOL...
As @Cope suggested with my very thin wires for my shifter switch and actually the full throttle switch I went ahead and used a 5 amp fuse to power that up to switch on the relay.. tomorrow I'll start on the MSD timing retard mechanism and tap into that wire as well for the MSD triggering.. I'm pretty sure it just needs to see 12 volts and no real amperage...