My 360 build.

I hear good and bad about the Mr Gasket head gaskets. I have not bought head gaskets yet. I was either going to use the 1008s or a set I have at home that are supposed to squish to .045. I know I went a little small with the cam and I want as much compression as I can get while being .020 down. Wallace says it will be a difference of 9.57 (.045 gasket) to 9.96 (.028 gasket). Will that be noticeable? If I knew I could get the Mr Gaskets to seal I'd try em for sure.
As far as the cam being a copy of anything, I have no idea. I told him what I wanted and he suggested a grind. I just took his suggestion. Solid Flat Tappet, 230/[email protected], 264/270 adv, .453/.473 lift (1.5 rocker), 112 lsa. 108 int centerline, Lash .022/.024, Int. open @ 7 close @ 43,Exh open @ 54 close @2, 9 degree overlap @ .050.

Cley